音频瞬时控制效果器soundspot nevo v1.0.1 最高音频控制VST插件音乐后期制作实时控制

流云高飞 · 发表于 2021-9-20 19:13:59

NEVO Is SoundSpot’s New Monster Clipper, Which Has Been Developed By Our In House Audio Wizards To Give You The Ultimate Peak Control When Either Mastering Audio, Or Enhancing Your Virtual Instruments Or Hardware Instruments.

NEVO是SoundSpot最新的Monster Clipper，由我们的内部音频向导开发，在掌握音频或增强虚拟乐器或硬件乐器时，为您提供终极峰值控制。

NEVO Is No Ordinary Clipper, There Are A Wealth Features And Controls That Will Leave You In Awe Of It’s Sonic Ability, Whilst At The Same Time Being Easy To Use And Totally Inspirational.

NEVO不是普通的克利伯，它有丰富的功能和控制，让你对它的声音能力感到敬畏，同时又易于使用，完全鼓舞人心。

Nevo Features A Combination Or A 16 Band Soft Clipper And A Single Band Hard Clipper, Along With Multiple Colouration Settings, A Transient Shaper And A Final Clip Wall Limiter. All Of These Features Have Been Arranged Into A Specific Signal Flow Which Has Been Meticulously Designed And Tested So You Can Get The Very Best Sound From Your Instruments, Groups, Mixes And Masters.

Nevo具有组合或16波段软剪和单波段硬剪，以及多种颜色设置、瞬时成型器和最终剪辑墙限制器。所有这些功能都被安排到一个特定的信号流中，经过精心设计和测试，因此您可以从您的乐器、组合、混音和大师中获得最佳的声音。

With An Infectious Workflow And Instant Results NEVO Is The Plugin You’ve Always Needed In Your Arsenal Of Audio Production Plugins……

凭借极具感染力的工作流程和即时效果，NEVO是音频制作插件库中您一直需要的插件……

nevo vst crack is stacked with the following features…..

nevo vst裂纹具有以下特征…。。

drive

开车

This function allows you to transition from light tape drive to hard tube drive when raising and lowering the % control. 0 – 50% will give you a tape style drive. 50 – 100% will then give you a tube style drive.

此功能允许您在升高和降低%控件时从轻型磁带机转换到硬盘管驱动器。0–50%将为您提供磁带式驱动器。50–100%将为您提供管状驱动。

curve

曲线

Adjusting this will allow you to transition through the clipping of the low and high end of your sound. Moving this control from Left to right will increase the effect on the high end, and then move Right to Left to increase the effect on the low end. Curve works by tilting the bias between high and low, whilst also lightly removing frequencies at the same time.

调整此选项将允许您通过声音的低端和高端剪辑进行过渡。将此控件从左向右移动将增加高端的效果，然后从右向左移动将增加低端的效果。Curve的工作原理是在高电平和低电平之间倾斜偏置，同时轻微地去除频率。

smooth

光滑的

The Smooth control works by increasing the release on the 16 clipping bands, whilst also smoothing out the effect of the Drive distortion.

平滑控制通过增加16个剪切带上的释放来工作，同时也平滑了驱动失真的影响。

crush

压碎

This function allows you dial in a Bit Crushing effect, which in turn provides control of how much sonic destruction is required for your signal. You will find that the Breach function will also affect this by softening the Crush strength when moving the dial from 0 to 100%..

此功能允许您拨入一个位压碎效果，从而控制信号需要多少声音破坏。您会发现，当将刻度盘从0%移动到100%时，破裂功能也会通过软化压碎强度来影响这一点。。

breach

违反

Using this function will allow you to control the amount of transients you may want to pass through the clipper control of your signal.

使用此功能将允许您控制您可能希望通过信号削波器控制的瞬变量。

soften

软化

This is like a smoothing function, but will only affect the single band of the hard clipper.

这类似于平滑函数，但只会影响硬剪裁器的单个频带。

Soften works in two ways.

软化有两种方式。

1, When Breach is at Zero, it will soften the Crush effect.

1，当破裂为零时，它将软化挤压效果。

2, When Breach is at 1 – 100%, it will give you a fatter sound whilst retaining the transients that Breach has allowed to pass.

2，当缺口为1–100%时，它会给你一个更胖的声音，同时保留缺口允许通过的瞬态。

colouration

着色

This control enables you to add three variations of colour to your sound. These options are, WARM, TRANSPARENT and BRIGHT.

此控件使您能够在声音中添加三种颜色。这些选项是温暖、透明和明亮的。

transient emphasis

暂时强调

This option gives you three types of transient emphasis in either the LOW, MID or HIGH frequencies.

此选项为您提供三种类型的低频、中频或高频瞬态强调。

clip wall

夹墙

This is a final brickwall limiter that also allows for your signal to be aggressively PULLED/SQUASHED to extremes.

这是最后一个砖墙限制器，也允许您的信号被积极地拉/压到极限。

waveform display, soft/hard clipper mix controls & signal level ring

波形显示、软/硬削波器混合控制和信号电平环

This central display gives you visual feedback details on the effect NEVO is having on your sound. Effects like the amount of transient being allowed back through the clipper control. The controls which are situated to the left and Right of the Waveform Display Window are mix controls for the soft and hard clippers. Left mix control is for the soft clipper, and Right mix control is for the hard clipper. The Waveform Display Window has a coloured ring/glow surrounding it that measures the amount of gain reduction generated by the clippers and end Clip Wall Limiter. If you are reaching extreme signal levels, it will abruptly turn Red. If you then reach acceptable levels, the ring will fall back to Blue.

这个中央显示屏为您提供有关NEVO对您声音影响的视觉反馈详细信息。通过clipper控件允许返回的瞬态量等影响。位于波形显示窗口左侧和右侧的控件是软硬削波器的混合控件。左混合控制用于软剪裁器，右混合控制用于硬剪裁器。波形显示窗口周围有一个彩色光环/辉光，用于测量限位器和端夹壁限制器产生的增益降低量。如果您达到极端信号水平，它将突然变为红色。如果你达到可接受的水平，戒指将回落到蓝色。

游客，如果您要查看本帖隐藏内容请回复